Basler A501kc Manual de usuario descargar pdf (Pagina 49)

Camera Interface

Basler A500

k 2-35

PRELIMINARY

2.10 Status LED

When the LED on the back of the camera is not lit, it means that no power is present. When the

LED is lit, it means that power to the camera is present.

Keep in mind that the circuit used to light the LED on the camera does not perform a voltage range

check. If power to the camera is present but it is out of range, the LED on the camera may be lit

but the camera will not operate properly.

When the LED on the back of the camera is orange this indicates signal integrity. At power up, the

LED will light for several seconds in orange and sometimes green as the microprocessor in the

camera boots up. If all is OK, the LED will then remain orange continuously.

If an error condition is detected at any time after the microprocessor boots up, the LED will begin

flashing an error code. See section 6 for details.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 149 150

Sin comentarios

Basler A501kc Manual de usuario Pagina 49