Basler A501kc Manual de usuario descargar pdf (Pagina 140)

Troubleshooting and Support

6-6 Basler A500k

PRELIMINARY

6.1.2.4 RS-644 Serial Communication

Use the serial communication troubleshooting charts if you think that there is a problem with RS-

644 serial communication or if you have been directed here from another chart.

The RS-644 port used by the A500k is located on the frame grabber. Check

the documentation for your frame grabber. Make sure that you have installed

all software related to the port and that the port has the following settings:

8 data bits, no parity, 1 stop bit, and baud rate = 9600 bps.

Is the port software installed and are the port settings correct?

Yes

Make corrections

and then restart

your computer.

Contact Basler technical support.

The contact numbers appear on the title page of this manual.

Serial Communication Chart (without a k-BIC)

Always switch off power to the system before making or breaking any connection.

Exit this

chart.

Start the CCT+ and select the port selector button below the menu

bar. A list will show any RS-644 port(s) available on the frame

grabber. Click on an RS-644 port in the list.

Do the camera settings appear in the right-side column?

The port is present but the CCT+ can not access the port.

Make sure that no other program has access to the port.

Yes

Does a “This type of camera is not

supported” message appear?

Yes

The RS-644 port is operating

correctly. Exit this chart.

You may need to update the CCT+. To download the latest

version of the tool, go to:

www.baslerweb.com

Once you have downloaded the latest version of the tool,

uninstall the old version of the tool from your computer and

install the new version.

Start the CCT+, click the “No port selected“ button, and select

an RS-644 port from the list.

Did you get the camera settings to appear?

Does a “Can‘t connect to the port because the

port is in use” message appear?

Yes

The port is present and can be accessed but the camera is

not responding. Make sure that:

The camera has power and that the power source meets

the requirements in section

2.8.

You are using the correct data cable between you camera

and the frame grabber (see section

2.2).

The wires in the data cable are continuous.

The cable connections are firmly seated.

After you made these checks, is the problem still present?

Yes

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 149 150

Comentarios a estos manuales

Sin comentarios

Basler A501kc Manual de usuario Pagina 140

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad Basler A501kc