Basler A501kc Manual de usuario descargar pdf (Pagina 118)

Configuring the Camera

4-22 Basler A500k

PRELIMINARY

4.2.4.16 FlashCtrl: Flash Trigger Modes

Purpose: To set the flash trigger mode or to read the current flash trigger mode setting. See sections

2.1.4 and 2.5.8 for an explanation of flash trigger modes.

Type: This is a read or write command.

Read Command: Cmd-ID R/W-Flag Data Length Data

0xAC 1 1 -

Response: Cmd-ID R/W-Flag Data Length Data

0xAC 0 1 1 Byte

Write Command: Cmd-ID R/W-Flag Data Length Data

0xAC 0 1 1 Byte

Response: None

Data Format: Byte 1 An ID that specifies the flash control mode

(see the table below).

ID Flash Trigger Mode (standard TTL, push/pull driver)

0x00 The FlashOut signal is always low.

0x01 The FlashOut signal is high while the in-

ternal Integrate Enabled signal is high.

0x02 The FlashOut signal is high while the

ExFlash signal from the frame grabber

is high.

0x03 The FlashOut signal is always high.

0x05 The FlashOut signal is low while the in-

ternal Integrate Enabled signal is high.

0x06 The FlashOut signal is low while the

ExFlash signal from the frame grabber

is high.

ID Advanced modes to combine with the upper modes

0x10 Open collector or Low Side Switch, 5 V max

0x20 High Side Switch 5 V

To combine an advanced mode with a

flash trigger mode, add the hexadecimal

number of the advanced code and the

one of the flash trigger mode together.

You can not select Low Side Switch and

High Side Switch at the same time.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 149 150

Sin comentarios

Basler A501kc Manual de usuario Pagina 118