Basler A600f Manual de usuario descargar pdf (Pagina 94)

Configuring the Camera

4-28 BASLER A600

DRAFT

4.4.2.4 Control and Status Registers for Format 7, Mode 0

Format 7, Mode 0 is available on all A600f cameras. The base address for each Format 7, Mode

0 camera control register is:

Bus ID, Node ID, FFFF F1F0 0000

In each Format 7, Mode 0 register description, an “Offset from the Base Address” is provided. This

is a byte offset from the above base address. The address of a Format 7, Mode 0 register equals

the above base address plus the indicated offset.

Values are stated in decimal format except when marked 0x. Values marked as 0x (e.g., 0x123)

are in hexadecimal format. Bit 0 in each register is the most significant bit.

Offset from Base Address: 0x000

Field Bit Description

Hmax 0 ... 15 Indicates the maximum horizontal image size in pixels.

Hmax = 656 on all A600f cameras

Vmax

16 ... 31 Indicates the maximum vertical image size in pixels.

Vmax = 491 on the A601f and A602f

Vmax = 490 on the A601fc and A602fc

Offset from Base Address: 0x004

Field Bit Description

Hunit

0 ... 15 Indicates the increment in columns for adjusting the area of interest

width (see Section 3.6). For example, if the Hunit is 2, the width should

be set in increments of 2.

Hunit = 1 on the A601f and A602f

Hunit = 2 on the A601fc and A602fc

Vunit 16 ... 31 Indicates the increment in rows for adjusting the area of interest height

(see Section 3.6). For example, if the Vunit is 1, the height should be

set in increments of 1.

Vunit = 1 on the A601f and A602f

Vunit = 2 on the A601fc and A602fc

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 179 180

Sin comentarios

Basler A600f Manual de usuario Pagina 94