Basler A600f Manual de usuario Pagina 178
- Pagina / 180
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Revision History
ii BASLER A600
f
DRAFT
DA00056107 2 March 2005 Added Sections 2.5.3 and 2.5.4 showing typical input circuit and typ-
ical output circuit diagrams.
Added Section 3.2.7 to clarify the terminology used to describe
frame readout, buffering and transmission.
Updated the YUV formulas in Section 3.7.
Reworded the white balance and color filter ID descriptions in Sec-
tions 3.7.1and 3.7.2 for better clarity.
Added information about the new strobe time base feature to Sec-
tions 3.10 and 6.7.12.
Added information about the new configuration sets and memory
channels to Sections 3.15, 4.4 and 6.7.11.
Reformatted and expanded the register descriptions in Section 4.4.
Added Section 5 describing image data formats and structures.
Corrected the CSR GUID for Output Port 3 configuration on page 6-
30.
DA00056108
5 December 2008 Corrected the contact information in the front pages.
Added Section 1.5.2 providing storage environmental requirements.
Added a warning not to remove the serial number tag to Section 1.6.
Added information about setting the minimum exposure time to the
section describing the level controlled exposure mode on page 3-10.
Corrected the description of using the software trigger to control
exposure start in Section 3.2.4.
Corrected the occurrence of “CMOS” in Section 3.2.7.
Corrected the contents of the bottom note box in Section 3.3.
Revised the formula for calculating the maximum frame rate based
on the sensor readout time in Section 3.6.2.
Corrected the description of the Memory Save Channel CSR on
page 4-19.
Removed the link related to downloading the SFF software from
Section 6.4.
Corrected the description of the Strobe Time Base CSR on
page 6-33.
Added Section 7.3 providing stress test information.
Added Section 8 describing how to approach technical support and
how to obtain an RMA number.
Updated all instances of the Basler web address.
DA00056109
7 December 2010 Updated the European and American contact addresses.
Added the PS2805C-4 optocoupler in Figure 2-3.
Removed the feedback page.
Doc. ID Number Date Changes
- Basler A600f 1
- Table of Contents 5
- 4 Configuring the Camera 6
- 1 Introduction 9
- Introduction 10
- 1-2 BASLER A600 10
- 1.3 Camera Models 11
- 1.4 Spectral Response 12
- 1.5.3 Ventilation 14
- 1.6 Precautions 15
- 1-8 BASLER A600 16
- 2 Camera Interface 17
- 2.1.2 Pin Assignments 18
- 2.1.3 Connector Types 19
- 2.2 Cables 20
- 2.3 Camera Power 20
- 2.5 Input and Output Ports 21
- Camera Interface 22
- 2-6 BASLER A600 22
- Figure 2-3: I/O Schematic 22
- 2.5.3 Typical Input Circuits 23
- 2.5.4 Typical Output Circuits 24
- 3 Basic Operation and 25
- Standard Features 25
- Figure 3-2: Block Diagram 27
- 3.2 Exposure Control 28
- Why Use the Software Trigger? 32
- Exposure Modes 33
- 3.2.7 Frame Buffering 38
- 3.3 Trigger Ready Signal 40
- 3.4 Integrate Enabled Signal 41
- 3.5 Gain and Brightness 42
- 3.5.1 Setting the Gain 43
- 3.5.2 Setting the Brightness 44
- 3.6 Area of Interest (AOI) 45
- ()45.84 µs+ 48
- 3.7.1 White Balance 50
- 3.7.2 Color Filter ID 51
- 3.9 Mirror Image 54
- Format 7, Mode 0 59
- Format 7, Mode 3 60
- Format 7, Mode 1 63
- 3.14 Error Flags 64
- 4.3 Configuration ROM 68
- 4.4.1 Inquiry Registers 69
- 4-4 BASLER A600 70
- 4-6 BASLER A600 72
- 4-8 BASLER A600 74
- 4-10 BASLER A600 76
- 4-14 BASLER A600 80
- 4-18 BASLER A600 84
- 4-20 BASLER A600 86
- 4-22 BASLER A600 88
- 4-24 BASLER A600 90
- 4-30 BASLER A600 96
- 4-32 BASLER A600 98
- Configuring the Camera 100
- 4-34 BASLER A600 100
- 4-36 BASLER A600 102
- BASLER A600 103
- 4-38 BASLER A600 104
- 4-40 BASLER A600 106
- 4-44 BASLER A600 110
- 4-46 BASLER A600 112
- 4-48 BASLER A600 114
- 4-52 BASLER A600 118
- 5 Image Data Formats and 121
- Structures 121
- 5.2.1 Format 0, Mode 1 122
- 5.2.2 Format 0, Mode 3 122
- 5.2.3 Format 0, Mode 5 122
- 5.3 Image Data Formats 123
- For Filter ID = 0 (RG / GB) 126
- For Filter ID = 1 (GB / RG) 127
- For Filter ID = 2 (GR / BG) 127
- For Filter ID = 3 (BG / GR) 128
- 5.4 Image Data Structure 133
- R, G or B (Raw 16) Component 134
- Features Framework 135
- 0-7 8-15 16-23 24-31 138
- 6.7.1 Extended Data Stream 143
- Smart Features 144
- 6-10 BASLER A600 144
- 6.7.2 Frame Counter 145
- 6.7.3 Cycle Time Stamp 146
- 6.7.4 DCAM Values 147
- DCAM Values Chunk Layout 148
- 6.7.5 CRC Checksum 150
- CRC Checksum Chunk Layout 151
- 6.7.6 Test Images 153
- Test Image Two 154
- Test Image Three 154
- 6.7.8 Lookup Table 157
- 6-30 BASLER A600 164
- 6.7.11 Startup Memory Channel 165
- 6.7.12 Strobe Time Base 166
- 6.8 Customized Smart Features 168
- 7 Mechanical Considerations 169
- 8 Technical Support 173
- Technical Support 176
- 8-4 BASLER A600 176
- Revision History 177
Relacionado con productos y manuales para Cámaras De Seguridad Basler A600f
Cámaras De Seguridad Basler A600f Manual de usuario
(124 paginas)
(124 paginas)
Cámaras De Seguridad Basler A501kc Manual de usuario
(150 paginas)
(150 paginas)
Cámaras De Seguridad Basler A501k Manual de usuario
(16 paginas)
(16 paginas)
Cámaras De Seguridad Basler A501k Manual de usuario
(150 paginas)
(150 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales