Basler A600f Manual de usuario Pagina 153
- Pagina / 180
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Smart Features
BASLER A600
f 6-19
DRAFT
6.7.6 Test Images
A600f cameras include a test image mode as a smart feature. The test image mode is used to
check the camera’s basic functionality and its ability to transmit an image via the video data cable.
The test image mode can be used for service purposes and for failure diagnostics. In test mode,
the image is generated with a software program and the camera’s digital devices and does not
use the optics, the CMOS pixel array, or the ADCs. Test images one, two, and three are available
on all A600
f cameras.
When a test image is active, the gain, brightness, and exposure time have no effect on the image.
Test Image one
As shown in Figure 6-3, test image one consists of rows with several gray scale gradients ranging
from 0 to 255. Assuming that the camera is operating at full 656 x 491 resolution and is set for a
monochrome, 8 bit output mode, when the test images are generated:
• row 0 starts with a gray value of 1 for the first pixel,
• row 1 starts with a value of 2 for the first pixel,
• row 2 starts with a gray vale of 3 for the first pixel, and so on.
(If the camera is operating at a lower resolution when the test images are generated, the basic
appearance of the test pattern will be similar to Figure 6-3, but the starting pixel values on each
row will not be as described above.)
The mathematical expression for test image one is:
Figure 6-3: Test Image One
L
The test image smart feature does not add information to the image data stream and
can be enabled even when the extended data stream feature (see Section 6.7.1) is
disabled.
The test image feature will work when the camera is set for any valid video format.
grayvalue [ x + y + 1 ] MOD256=
- Basler A600f 1
- Table of Contents 5
- 4 Configuring the Camera 6
- 1 Introduction 9
- Introduction 10
- 1-2 BASLER A600 10
- 1.3 Camera Models 11
- 1.4 Spectral Response 12
- 1.5.3 Ventilation 14
- 1.6 Precautions 15
- 1-8 BASLER A600 16
- 2 Camera Interface 17
- 2.1.2 Pin Assignments 18
- 2.1.3 Connector Types 19
- 2.2 Cables 20
- 2.3 Camera Power 20
- 2.5 Input and Output Ports 21
- Camera Interface 22
- 2-6 BASLER A600 22
- Figure 2-3: I/O Schematic 22
- 2.5.3 Typical Input Circuits 23
- 2.5.4 Typical Output Circuits 24
- 3 Basic Operation and 25
- Standard Features 25
- Figure 3-2: Block Diagram 27
- 3.2 Exposure Control 28
- Why Use the Software Trigger? 32
- Exposure Modes 33
- 3.2.7 Frame Buffering 38
- 3.3 Trigger Ready Signal 40
- 3.4 Integrate Enabled Signal 41
- 3.5 Gain and Brightness 42
- 3.5.1 Setting the Gain 43
- 3.5.2 Setting the Brightness 44
- 3.6 Area of Interest (AOI) 45
- ()45.84 µs+ 48
- 3.7.1 White Balance 50
- 3.7.2 Color Filter ID 51
- 3.9 Mirror Image 54
- Format 7, Mode 0 59
- Format 7, Mode 3 60
- Format 7, Mode 1 63
- 3.14 Error Flags 64
- 4.3 Configuration ROM 68
- 4.4.1 Inquiry Registers 69
- 4-4 BASLER A600 70
- 4-6 BASLER A600 72
- 4-8 BASLER A600 74
- 4-10 BASLER A600 76
- 4-14 BASLER A600 80
- 4-18 BASLER A600 84
- 4-20 BASLER A600 86
- 4-22 BASLER A600 88
- 4-24 BASLER A600 90
- 4-30 BASLER A600 96
- 4-32 BASLER A600 98
- Configuring the Camera 100
- 4-34 BASLER A600 100
- 4-36 BASLER A600 102
- BASLER A600 103
- 4-38 BASLER A600 104
- 4-40 BASLER A600 106
- 4-44 BASLER A600 110
- 4-46 BASLER A600 112
- 4-48 BASLER A600 114
- 4-52 BASLER A600 118
- 5 Image Data Formats and 121
- Structures 121
- 5.2.1 Format 0, Mode 1 122
- 5.2.2 Format 0, Mode 3 122
- 5.2.3 Format 0, Mode 5 122
- 5.3 Image Data Formats 123
- For Filter ID = 0 (RG / GB) 126
- For Filter ID = 1 (GB / RG) 127
- For Filter ID = 2 (GR / BG) 127
- For Filter ID = 3 (BG / GR) 128
- 5.4 Image Data Structure 133
- R, G or B (Raw 16) Component 134
- Features Framework 135
- 0-7 8-15 16-23 24-31 138
- 6.7.1 Extended Data Stream 143
- Smart Features 144
- 6-10 BASLER A600 144
- 6.7.2 Frame Counter 145
- 6.7.3 Cycle Time Stamp 146
- 6.7.4 DCAM Values 147
- DCAM Values Chunk Layout 148
- 6.7.5 CRC Checksum 150
- CRC Checksum Chunk Layout 151
- 6.7.6 Test Images 153
- Test Image Two 154
- Test Image Three 154
- 6.7.8 Lookup Table 157
- 6-30 BASLER A600 164
- 6.7.11 Startup Memory Channel 165
- 6.7.12 Strobe Time Base 166
- 6.8 Customized Smart Features 168
- 7 Mechanical Considerations 169
- 8 Technical Support 173
- Technical Support 176
- 8-4 BASLER A600 176
- Revision History 177
Relacionado con productos y manuales para Cámaras De Seguridad Basler A600f
Cámaras De Seguridad Basler A600f Manual de usuario
(124 paginas)
(124 paginas)
Cámaras De Seguridad Basler A501kc Manual de usuario
(150 paginas)
(150 paginas)
Cámaras De Seguridad Basler A501k Manual de usuario
(16 paginas)
(16 paginas)
Cámaras De Seguridad Basler A501k Manual de usuario
(150 paginas)
(150 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales