Basler BIP2-DXXXXc-dn Manual de usuario descargar pdf (Pagina 95)

AW00101507000 Terminal Blocks and Audio Connector

Basler IP Fixed Dome Cameras 91

5.2 The RS-485 Terminal Block

The 3-hole terminal block on the right side of the camera base can be used to make an RS-485

connection to the camera.

The assignments for the wire fixing holes in the terminal block are as shown below. The A+, B-, and

Gnd connections are standard for an RS-485 connection. The RS-485 ground is isolated from the

camera’s power ground and I/O ground.

Fig. 12: RS-485 Terminal Block

The terminal block is a push-in type of connector. Either solid or stranded wires can be inserted into

the wire fixing holes in the terminal block. A wire can be removed from a fixing hole by pressing the

release tab above the hole and pulling on the wire.

Wires inserted into the fixing holes must have a minimum cross section of 0.2 mm

2

(AWG 24) and

a maximum cross section of 1.5 mm

2

(AWG 16).

8 mm (5/16") of insulation should be stripped from the end of a wire before it is inserted into a fixing

hole.

Wire

Fixing

Holes

Release

Tabs

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 127 128

Comentarios a estos manuales

Sin comentarios