Basler BIP2-DXXXXc-dn Manual de usuario descargar pdf (Pagina 51)

AW00101507000 Configuring the Camera

Basler IP Fixed Dome Cameras 47

Email Password - Enter a password for authentication on the SMTP server. Up to 29 characters

can be used. All standard keyboard characters are valid.

Email From - Enter an email address to appear as the sender’s address in the email sent by the

camera. You can use the variable $hostname$ as part of the address, and the variable will be

replaced with the camera’s actual host name.

HTTP Tab

The camera will automatically add the following parameters to the end of the URL:

host=<hostname> = the camera’s host name, typically something like this: "Basler-20809681"

date=<date/time> = the date and time when the alarm has been declared, e.g.:

"2012-01-03 16:30:41 CEST".

(How to set the date and time format and the time zone, see Section 3.12.2 on

page 74.)

ts=<timestamp> = time in sec:µsec since 1 Jan 1970, 0:00:00 GMT, when the alarm has been

declared, e.g. something like this: "1330342430.625201"

nr=<alarm number> = the number of the alarm, e.g. "2".

Source_User=<boolean> = if the user is the source that has declared the alarm, the value is set to

"1", otherwise to "0".

Source_PIO=<boolean> = if the camera I/O ports are enabled as a source for declaring an alarm

condition and an active signal becomes present on a camera I/O port,

the value is set to "1", otherwise to "0".

Source_Motion=<boolean> = if motion detection is enabled as an alarm source and motion is

detected, the value is set to "1", otherwise to "0".

Source_Cyclic=<boolean> = if the cyclic alarm source has been enabled to declare a recurrent

alarm, the value is set to "1", otherwise to "0".

Source_Heartbeat=<boolean> = if the heartbeat missing alarm source has been enabled and a

heartbeat timeout occurs, the value is set to "1", otherwise to "0".

If motion detection is enabled as an alarm source and motion is detected, the camera will

automatically add the following parameters to the end of the above mentioned parameters.

MotionDetected=<boolean> = if motion has been detected, the value is set to "1".

MotionRegion_0=<boolean> = if motion has been detected in motion detection region 0, the value

is set to "1", otherwise to "0".

Action Enable - Check the Action Enable box on the HTTP tab to

enable the sending of an HTTP request as an action to take when

an alarm condition is declared.

HTTP URL - Enter a valid URL. You could, for example, enter this

URL: http://MyServer/cgi-bin/alarm.cgi

The transmitted string will be URL encoded.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 127 128

Comentarios a estos manuales

Sin comentarios