Basler BIP2-DXXXXc-dn Manual de usuario descargar pdf (Pagina 69)

AW00101507000 Configuring the Camera

Basler IP Fixed Dome Cameras 65

3.9.2 Serial I/O Tab

The parameters on the Serial I/O tab are used to configure the camera’s RS-485 serial port.

Line Configuration - Sets the line configuration for the serial port in Data Bits, Parity, Stop Bit

format. For example, 8N1 means 8 data bits, no parity, 1 stop bit.

Port - Sets the port to listen to for incoming TCP/IP traffic. If Forwarding is enabled, all traffic will

be forwarded to the serial port.

Authentication - If the Authentication box is checked, then a login will be required to access the

serial port.

User Name - Sets the user name for access to the serial port. Up to 15 numbers and/or letters

(upper or lower case) can be used.

Password - Sets the password for access to the serial port. Up to 29 characters can be used. All

standard keyboard characters are valid.

Commit - Click the Commit button to save any changes you have made to the settings.

Forwarding - Check the Forwarding box to enable serial port

forwarding. When forwarding is enabled, serial commands issued

via TCP/IP over the designated port (see the Port parameter below)

will be forwarded to the serial port.

Forwarding Mode - Sets the mode for serial port forwarding.

 Telnet = The network connection behaves like a normal telnet

connection using the byte "0xFF" as an escape character for

the input of commands.

 Raw = Only the data from the serial port is transmitted over the

network without any interpretation.

Baud Rate - Sets the baud rate for the serial port (in bits per

second).

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 127 128

Comentarios a estos manuales

Sin comentarios