
Physical Interface AW00104701000
62 Basler scout light GigE
7.5 Camera Power
Camera power must be supplied to the camera’s 12-pin connector via the standard power and I/O
cable or via the PLC power and I/O cable. Power consumption is as shown in the specification
tables in Section 1 of this manual.
The following voltage requirements apply to the camera power VCC (pins 8 and 9 of the 12-pin
receptacle):
NOTICE
Voltage Outside of Specified Range Can Cause Damage.
If the voltage of the power to the camera is greater than +30.0 VDC damage to the camera can
result. If the voltage is less than +11.3 VDC, the camera may operate erratically.
NOTICE
Avoid Applying Voltage to the Non-functional Pins.
Applying voltages to the non-functional pins in the 12-pin connector may damage the electronic
components in the camera. We recommend that you do not apply signals to any of the non-
functional pins.
NOTICE
An Incorrect Plug Can Damage the 12-pin Connector.
The plug on the cable that you attach to the camera’s 12-pin connector must have 12 pins. Use
of a smaller plug, such as one with 10 pins or 8 pins, can damage the pins in the camera’s 12-pin
connector.
Voltage Significance
< +11.3 VDC The camera may operate erratically.
+12 to +24 VDC Recommended operating voltage; < 1 % ripple required. Make sure to use a power
supply that supplies power in this voltage range.
+30.0 VDC Absolute maximum; the camera may be damaged when the absolute maximum is
exceeded.
Table 5: Voltage Requirements for the Camera Power VCC
Comentarios a estos manuales