Basler A400K Manual de usuario descargar pdf (Pagina 117)

AW00118501000 Features

Basler racer Camera Link 109

Default Startup Set

You can select the default configuration set or one of the user configuration sets stored in the

camera’s non-volatile memory to be the "default startup set." The configuration set that you

designate as the default startup set will be loaded into the active set whenever the camera starts

up at power on or after a reset. Instructions for selecting the default startup set appear in

Section 8.13.3 on page 111.

8.13.1 Saving Configuration Sets

Saving the current active set into a user set in the camera’s non-volatile memory is a three step

process:

 Make changes to the camera’s settings until the camera is operating in a manner that you

would like to save.

 Set the User Set Selector to User Set 1, User Set 2, or User Set 3.

 Execute a User Set Save command to save the active set to the selected user set.

Saving an active set to a user set in the camera’s non-volatile memory will overwrite any parameters

that were previously saved in that user set.

Saving User Sets Using Basler pylon

You can set the User Set Selector and execute the User Set Save command from within your

application software by using the pylon API. The following code snippet illustrates using the API to

set the selector and execute the command:

Camera.UserSetSelector.SetValue( UserSetSelector_UserSet1 );

Camera.UserSetSave.Execute( );

For detailed information about using the pylon API, refer to the Basler pylon Programmer’s Guide

and API Reference.

You can also use the Basler pylon Viewer application to easily set the parameters.

For more information about the pylon Viewer, see Section 3.1 on page 15.

Saving User Sets Using Direct Register Access

To save the current active set to a user set in the camera’s non-volatile memory via direct register

access:

 Make changes to the camera’s settings until the camera is operating in a manner that you

would like to save.

 Set the value of the User Set Selector register to User Set 1, 2, or 3 as desired.

 Set the value of the User Set Save register to 1.

For more information about direct register access, see Section 3.2 on page 16.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 129 130

Sin comentarios

Basler A400K Manual de usuario Pagina 117